Stall Speed Test
Stall Speed Test1. Engage the parking brake, and block all four wheels.
2. Connect the HDS to the DLC (A), and go to the A/T data list.
3. Make sure the A/C switch is OFF.
4. After the engine has warmed up to normal operating temperature (the radiator fan comes on), shift to the [D] position.
5. Fully press the brake pedal and accelerator pedal for 6 to 8 seconds, and note the maximum engine speed. Do not move the shift lever while raising engine speed.
6. Allow 2 minutes for cooling, then repeat the test in the [R] position.
NOTE:
- Do not test stall speed for more than 10 seconds at a time.
- Stall speed tests should be used for diagnostic purposes only.
- Stall speed should be the same in [D] and [R] positions.
- Do not test stall speed with the A/T pressure gauges installed.
Stall Speed rpm:
Specification: 2,000 rpm
Service Limit: 1,850 - 2,150 rpm
7. If the measurements are out of the service limit, problems and probable causes are listed in the table shown.