Seat Belt Buckle Replacement

Front Seat Belt Replacement

SRS components are located in this area. Review the SRS component locations, and the precautions and procedures before performing repairs or service.

NOTE: Check the front seat belts for damage, and replace them if necessary. Be careful not to damage them during removal and installation.

Seat Belt Buckle
1. Make sure you have the anti theft code for the radio and the navigation system, then write down the frequencies for the preset buttons
2. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work
3. Remove the front seat
4. Manual seat Remove the center cover







5. Disconnect or detach the seat belt switch connector (A) and harness clip (B)







6. Remove the center anchor bolt (A), and detach the harness clip (B), then remove the seat belt buckle (0
7. Pull the seat belt switch harness (D) out through the space between the seat cushion and the seat linkage, or the hole on the seat track




8. Install the buckle in the reverse order of removal, and note these items
- Assemble the washers on the center anchor bolt as shown
- Reconnect the negative cable to the battery
- Enter the anti-theft codes for the radio and the navigation system, then enter the customer's radio station presets
- Reset the clock

9. Move the seat all the way forward and backward, and confirm that the seat buckle harness is routed properly.