CKP Pulse Plate

CKP Pulse Plate Replacement
1. Remove the front tires/wheels.
2. Remove the splash shield.
3. Remove the drive belt.
4. Remove the cylinder head cover.
5. Remove the crankshaft pulley.
6. Disconnect the Crankshaft Position (CKP) sensor connector and variable Valve Timing Control (VTC) oil control solenoid valve connector.
7. Remove the VTC oil control solenoid valve.
8. Support the engine with a jack and wood block under the oil pan.
9. Remove the ground cable, and remove the upper bracket.
10. Remove the side engine mount bracket.
11. Remove the chain case.





12. Remove the CKP pulse plate.
13. Install the CKP pulse plate.
14. Check the chain case oil seal for damage. If the oil seal is damaged, replace the chain case oil seal.
15. Remove old liquid gasket from the chain case mating surfaces, bolt and bolt holes.
16. Clean and dry the chain case mating surfaces.
17. Apply liquid gasket, P/N 08718-0009, evenly to the cylinder block mating surface of the chain case and to the inner threads of the holes.
18. Apply liquid gasket to the cylinder block upper surface contact areas on the chain case.
19. Apply liquid gasket, P/N 08718-0009, evenly to the oil pan mating surface of the chain case and to the inner threads of the holes.

NOTE: Do not install the parts if 4 minutes or more have elapsed since applying liquid gasket. Instead, reapply liquid gasket after removing the old residue.

20. Install the new O-ring on the chain case. Set the edge of the chain case to the edge of the oil pan, then install the chain case on the cylinder block.

NOTE: When installing the chain case, do not slide the bottom surface on the oil pan mounting surface.

21. Install the side engine mount bracket.
22. Install the upper bracket and the ground cable.
23. Install the VTC oil control solenoid valve.
24. Connect the CKP sensor connector and VTC oil control solenoid valve connector.
25. Install the crankshaft pulley.
26. Install the cylinder head cover.
27. Install the drive belt.
28. Install the splash shield.
29. Install the front tires/wheels.
30. Perform the CKP pattern clear/CKP learn procedure below.

CKP PATTERN CLEAR/CKP Pattern Learn Procedure

Enable Criteria
ECT at 176 °F (80 °C) or higher.

Procedure
1. Do the CKP PATTERN CLEAR in the CLEAR MENU with the HDS while the engine is stopped.
2. Turn the ignition OFF.
3. Turn the ignition ON (II), and wait for 30 seconds.
4. Test drive the vehicle on a level road Decelerate (with the throttle fully closed) from engine speed of 2,500 rpm to 1,000 rpm with the A/T in 2 position, or the M/T in 2nd or 3rd gear.
5. Stop the vehicle Do not turn the ignition off.
6. Select the ALL DATA LIST in the DATA LIST MENU of the HDS.
7. Check the status of PULSER F/B LEARN. If it is set to NG, the enable criteria was probably not met, repeat the procedure from the beginning.