Start-Up Procedure and Diagnosis Menu

Start-up Procedure and Diagnosis Menu




1. Turn the ignition switch ON (II).
A. If the battery has not been disconnected, then press and hold Menu, Map/Guide, and Cancel buttons. Keep them pressed for approximately 5 seconds. The display screen then goes directly to the "Select Diagnosis Items" menu.

B. If the battery was disconnected and reconnected prior to this test hold down the Menu and Zoom Out button. You will see the "Navi System Link" screen. Push the joystick to go directly to the "Select Diagnosis Items" menu.

NOTE: This only allows access to the diagnostic screens. All other Navigation functions are disabled

2. After the display changes to the select Diagnosis Items menu, touch the item you want to check, and the check will start. To return to the previous screen, touch "Return".
- Navi System. (Link)
- F-CAN (System Link)
- B-CAN (System Link)
- Monitor Check.
- Unit Check.
- Car Status.
- GPS Information
- Yaw Rate.
- Tire Calibrate.
- Functional Setup.
- Version.